This form calculates accurate mixtures of two solutions.
It is intended mainly for adding hydrogen peroxide to either colloidal
silver or distilled water at varying concentration strengths.
To find out what an end solution strength is, enter the
following: (1) for X, enter the amount of the INITIAL Hydrogen Peroxide
used 2) enter the strength of this solution, often 35%. (3) Enter the
amount of distilled water/CS to be used 3) Enter the solution strength
of your second solution. If you are using a distilled water or an ionic
silver base that does not contain any H2O2, enter ZERO for the Solution
2 strength.
If you are interested in calculating the amount of actual
silver in your solution, then enter the estimated PPM of your initial
colloidal silver solution. This value does not effect any of the H2O2
calculations.
Press the calculate button. The data that is populated
on the next page will 1) verify your input data, and 2) provide the percentage
of H2O2 ( Solution 1 ) and the amount of the final solution.
Of course, this form is not limited to use with H2O2.